| CONTACT LOAD CURRENT RATING | 25.0 AMPERES RESISTIVE LOAD AND 25.0 AMPERES INDUCTIVE LOAD DC AT SEA LEVEL |
| CONTACT LOAD CURRENT RATING | 30.0 AMPERES RESISTIVE LOAD AND 30.0 AMPERES INDUCTIVE LOAD AC AT SEA LEVEL |
| CONTACT VOLTAGE RATING IN VOLTS | 250.0 DC AT SEA LEVEL |
| CONTACT VOLTAGE RATING IN VOLTS | 450.0 AC AT SEA LEVEL |
| CRITICALITY CODE JUSTIFICATION | FEAT |
| FEATURES PROVIDED | ACTUATOR KNOB |
| FIRST FLAT LENGTH | 0.500 INCHES NOMINAL SINGLE ACTUATOR |
| FLAT HEIGHT | 0.310 INCHES MINIMUM AND 0.312 INCHES MAXIMUM SINGLE ACTUATOR |
| INDIVIDUAL SECTION QUANTITY | 3 |
| KNOB MANUFACTURER CODE | 80064 |
| KNOB MANUFACTURER PART NUMBER | 9000-S6202-74089 PIECE 3 |
| KNOB SPECIAL MARKINGS | DIRECTIONAL ARROW ON TOP |
| OVERALL HEIGHT | 3.688 INCHES NOMINAL |
| OVERALL LENGTH | 3.938 INCHES NOMINAL |
| OVERALL WIDTH | 4.375 INCHES NOMINAL |
| MOUNTING FACILITY CIRCLE RADIUS | 1.610 INCHES NOMINAL SINGLE MOUNTING FACILITY |
| MOUNTING FACILITY PATTERN | FOUR POSITION CIRCULAR SINGLE MOUNTING FACILITY |
| MOUNTING METHOD | BRACKET AND UNTHREADED HOLE SINGLE MOUNTING FACILITY |
| POLE QUANTITY | 2 EACH SECTION REAR |
| SHAFT DIAMETER | 0.375 INCHES NOMINAL SINGLE ACTUATOR |
| SHAFT TYPE | ROUND, FLATTED, THREADED HOLE SINGLE ACTUATOR |
| SHAFT LENGTH | 0.875 INCHES NOMINAL SINGLE ACTUATOR |
| SPECIAL FEATURES | WEAPON SYSTEM ESSENTIAL |
| SPECIFICATION/STANDARD DATA | 81349-MIL-S-15291/6 GOVERNMENT SPECIFICATION |
| STYLE DESIGNATOR | TAP, CIRCUIT SELECTOR |
| SWITCH ACTUATOR INDEXING POSITION QUANTITY | 4 SINGLE ACTUATOR |
| SWITCH ACTUATOR POSITIONING INCREMENT | 90.0 DEGREES SINGLE ACTUATOR |
| SWITCH CONTACT BASIC DESIGN | NONPILE-UP SYMMETRICAL |
| TERMINAL TYPE | TAB W/SCREW |
| TEST DATA DOCUMENT | 81349-MIL-S-15291 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
| THROW QUANTITY | 1 SINGLE SECTION FRONT |
| UNTHREADED MOUNTING HOLE DIAMETER | 0.323 INCHES NOMINAL SINGLE MOUNTING FACILITY |