| CONTACT LOAD CURRENT RATING | 1.0 AMPERES RESISTIVE LOAD AC AT SEA LEVEL |
| CONTACT LOAD CURRENT RATING | 1.0 AMPERES RESISTIVE LOAD DC AT SEA LEVEL |
| CONTACT SWITCHING ACTION | BREAKS BEFORE MAKES EACH SECTION REAR |
| CONTACT VOLTAGE RATING IN VOLTS | 115.0 AC AT SEA LEVEL |
| CONTACT VOLTAGE RATING IN VOLTS | 28.0 DC AT SEA LEVEL |
| DETENT ROTATIONAL TORQUE RANGE | +2.000 TO 11.000 INCH-POUNDS SINGLE ACTUATOR |
| FIRST FLAT LENGTH | 0.740 INCHES MINIMUM AND 0.760 INCHES MAXIMUM SINGLE ACTUATOR |
| FLAT HEIGHT | 0.211 INCHES MINIMUM AND 0.221 INCHES MAXIMUM SINGLE ACTUATOR |
| INDIVIDUAL SECTION QUANTITY | 3 |
| LONGEST HORIZONTAL DISTANCE BETWEEN MOUNTING CENTERS | 1.495 INCHES MINIMUM AND 1.505 INCHES MAXIMUM SINGLE MOUNTING FACILITY |
| OVERALL HEIGHT | 2.266 INCHES MAXIMUM |
| OVERALL LENGTH | 4.463 INCHES MAXIMUM |
| OVERALL WIDTH | 2.266 INCHES MAXIMUM |
| MOUNTING FACILITY PATTERN | TWO POSITION IN-LINE SINGLE MOUNTING FACILITY |
| MOUNTING METHOD | THREADED HOLE SINGLE MOUNTING FACILITY |
| NOMINAL THREAD SIZE | 0.164 INCHES SINGLE MOUNTING FACILITY |
| OPERATING TEMP RANGE | -65.0 TO 85.0 CELSIUS |
| POLE QUANTITY | 1 EACH SECTION REAR |
| SHAFT DIAMETER | 0.248 INCHES MINIMUM AND 0.251 INCHES MAXIMUM SINGLE ACTUATOR |
| SHAFT LENGTH | 0.806 INCHES MINIMUM AND 0.869 INCHES MAXIMUM SINGLE ACTUATOR |
| SHAFT FLAT/SLOT ANGULAR LOCATION | 330.0 DEGREES FROM CONTACT POSITION 1 SINGLE ACTUATOR |
| SHAFT TYPE | ROUND, FLATTED SINGLE ACTUATOR |
| STYLE DESIGNATOR | TAP, SQUARE FRAME |
| SWITCH ACTUATOR POSITIONING INCREMENT | 30.0 DEGREES SINGLE ACTUATOR |
| SWITCH CONTACT BASIC DESIGN | NONPILE-UP SYMMETRICAL |
| SWITCH ACTUATOR INDEXING POSITION QUANTITY | 12 SINGLE ACTUATOR |
| TERMINAL TYPE | TURRET |
| TEST DATA DOCUMENT | 81349-MIL-S-3786 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
| THREAD CLASS | 2B SINGLE MOUNTING FACILITY |
| THREAD QUANTITY PER INCH | 32 SINGLE MOUNTING FACILITY |
| THREAD SERIES DESIGNATOR | UNC SINGLE MOUNTING FACILITY |
| THROW QUANTITY | 12 EACH SECTION REAR |