|
|
|
National Stock Number:
5905-00-504-4625
Federal Supply Class:
5905
National Item Identification Number:
005044625
Description:
RESISTOR,FIXED,WIRE WOUND,INDUCT
Detail:
INC 37403 REINSTATED ON 010303~A resistor whose ohmic value cannot be adjusted or varied. The resistance element consists of high resistance wire (or ribbon) either wound on an insulated form or constructed so as to be self-supporting. The item must have inherent characteristics of inducing self-inductance. Opposition to current flow is an inherent property of the resistance wire and is manifested by the heat dissipation in the resistor. Excludes SUPPRESSOR, IGNITION INTERFERENCE. See also RESISTOR (1), FIXED, WIRE WOUND, NONINDUCTIVE.
|
Manufacturer Information:
| 36878-3 | 44655 | OHMITE HOLDING, L.L.C. | | P19C7498-3 | 79500 | WESTINGHOUSE ELECTRIC CORP | | P19C7498-3 | 83843 | SUNDSTRAND CORP ELECTRIC POWER SYSTEMS DIV | | P19C7498-3 | 99167 | HAMILTON SUNDSTRAND CORPORATION | | R4934-3 | 83827 | RESISTORS INC |
|
Techincal Specification:
| ELECTRICAL RESISTANCE | 1.200 KILOHMS | | AMBIENT TEMP AT FULL RATED POWER | 25.0 CELSIUS | | AMBIENT TEMP IN DEG CELSIUS AT ZERO PERCENT RATED POWER | 325.0 | | BODY LENGTH | 1.750 INCHES NOMINAL | | FIXED TAP TERMINAL TYPE | TAB, SOLDER LUG | | FIXED TAP QUANTITY | 1 | | INCLOSURE TYPE | ENCAPSULATED | | POWER DISSIPATION RATING IN WATTS | 10.000 FREE AIR | | RELIABILITY INDICATOR | NOT ESTABLISHED | | RESISTANCE TOLERANCE IN PERCENT | -5.000 TO 5.000 | | SECTION NOMINAL RESISTANCE | 500.000 OHMS 1ST SECTION | | SECTION NOMINAL RESISTANCE | 700.000 OHMS 2ND SECTION | | STYLE DESIGNATOR | RADIAL TERMINAL EACH END | | TEMP RANGE OF TEMP COEFFICIENT IN DEG CELSIUS | -65.0 TO 330.0 | | TEMP COEFFICIENT OF RESISTANCE IN PPM PER DEG CELSIUS | -400.0 TO 400.0 | | TERMINAL LENGTH | 0.391 INCHES NOMINAL | | TERMINAL TYPE | TAB, SOLDER LUG | | TERMINAL WIDTH | 0.219 INCHES NOMINAL | | TEST DATA DOCUMENT | 83843-+19C7498 DRAWING (THIS IS THE BASIC GOVERNING DRAWING, SUCH AS A CONTRACTOR DRAWING, ORIGINAL EQUIPMENT MANUFACTURER DRAWING, ETC.; EXCLUDES ANY SPECIFICATION, STANDARD OR OTHER DOCUMENT THAT MAY BE REFERENCED IN A BASIC GOVERNING DRAWING) |
|
|