|
|
|
National Stock Number:
5310-00-427-9861
Federal Supply Class:
5310
National Item Identification Number:
004279861
Description:
WASHER,FLAT
Detail:
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use SHIM. For items fabricated from ceramic or electrically rated materials by specification or industry standards use INSULATOR (1), WASHER. Excludes DISK, VALVE, graphite impregnated and lubricated items.
|
Manufacturer Information:
| A89816-44 | 80020 | NAVAL AIR WARFARE CENTER AIRCRAFT DIVISION CODE 4.8.8.0.0.B BLDG 148-2 |
|
Techincal Specification:
| MATERIAL | STEEL COMP 1095 OVERALL | | MATERIAL DOCUMENT AND CLASSIFICATION | MIL-S-7947,COND 2 MIL SPEC SINGLE MATERIAL RESPONSE OVERALL | | SURFACE TREATMENT | ZINC OVERALL | | CENTER HOLE SHAPE STYLE | ROUND | | HOLE DIAMETER | 0.906 INCHES NOMINAL | | PERIPHERAL SHAPE STYLE | ROUND | | OVERALL DIAMETER | 1.487 INCHES MINIMUM AND | | 1.516 INCHES MAXIMUM | | CROSS-SECTIONAL SHAPE STYLE | RECTANGULAR | | THICKNESS | 0.087 INCHES MINIMUM AND | | 0.093 INCHES MAXIMUM | | TEST DATA DOCUMENT | 81349-MIL-I-6868 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). | | MINIMUM TENSILE STRENGTH | 185000 POUNDS PER SQUARE INCH | | THE MANUFACTURERS DATA | | | MANUFACTURERS CODE | 80020 | | DESIGN CONTROL REFERENCE | A89816-44 |
|
|