Techincal Specification:
| ELECTRIC MOTOR HORSEPOWER RATING | 0.750 | | ELECTRIC MOTOR QUANTITY | 1 | | ACCESSORY COMPONENTS AND QUANTITY | 4 BELTS/V/;1 BUSHING,SPINDLE CTR.;2 CTRS.,TAILSTOCK,HEADSTOCK,NO.2 MORSE TAPER;1 CHUCK,LATHE,IND.,MED.DUTY,4 JAW,10 IN.W/WRENCH;1 CHUCK,LATHE,SCROLL SELF CTR.,MED.DUTY,3 JAW,UNIV.,W/REV.JAWS,6 IN.W/WRENCH;24 CUTTER BIT,TOOL HOLDER H-SPEED STEEL,UNFINISHED,SQ,5/16BY2-3/4 IN.;1 CUTTER BIT,TOOL HOLDER,UNFINISHED,BEVELED,1/8BY3/4BY6 IN.;3 CUTTER BIT,TOOL HOLDER,UNFINISHED,SQ,1/4BY2-1/8 IN.;1 DIAL,INDICATING,THD CHASING;1 DOG SET,1 EA,BENT TAIL,SINGLE SCREW 1/2,3/4,1,1-1/4,1-1/2 IN.CAP;1 HOLDER,CUTTING TOOL,BORING W/BORING BAR,30,45 AND 90 DEG END CAPS,CUTTER BITS AND WRENCH,1/2BY1-1/8 IN.SHANK,3/4 IN.BAR DIA;1 HOLDER,CUTTING OFF,STRAIGHT SHANK,W/CUTTER BIT,AND WRENCH,1/2BY1-1/8 IN.SHANK;1 EA RH,LH,STRAIGHT HOLDER,CUTTING TOOL,TURNING,OFFSET,W/CUTTER BIT AND WRENCH,1/2BY1-1/8 IN.SHANK;1 EA WRENCH,TAILSTOCK,TOOL POST | | ACTUAL SWING OVER BED | 12.500 INCHES NOMINAL | | CARRIAGE FEED CHANGE QUANTITY | 57 | | CARRIAGE CROSS FEED OPERATION METHOD | HAND AND POWER | | CARRIAGE QUANTITY | 1 | | CENTER TO CENTER DISTANCE | 35.000 INCHES NOMINAL | | CURRENT TYPE | AC | | FREQUENCY IN HERTZ | 60.0 | | HEADSTOCK DRIVE TYPE | GEARED HEAD | | HOLE DIAMETER THROUGH SPINDLE | 1.313 INCHES NOMINAL | | MOUNTING TYPE | BENCH | | SPECIAL FEATURES | 1 KNURLING TOOL,LATHE,SELF-CTR.,W/DIAMOND KNURLS 1/2BY1-1/8 IN.SHANK;1 EA MANDREL,EXPANSION,SLEEVE,1/2TO11/16,11/16TO1,1TO1-9/32,1-9/32TO1-9/16 IN-.RNAGE;1 EA,PLATE,ADAPTER,CHUCK MTG,UNFINISHED,5,5-7/8 IN.DIA;1 EA PLATE,FACE,11,5 IN.DIA;1 POST,TOOL;1 EA REST,FOLLOWER,STEADY;1 SCREW,THD DEPTH STOP/SPEC/;1 STOP,THD DEPTH;1 EA WRENCH,BOX,DOUBLE HEAD,12 POINT,LG 15 DEG OFFSET,9/16 AND 5/8,1-1/16 AND 1-1/4 IN. OPENINGS | | PHASE | SINGLE | | RATED SWING | 12.000 INCHES NOMINAL | | SPINDLE SPEED QUANTITY | 8 | | VOLTAGE IN VOLTS | 115.0 AND 230.0 |
|